TexMaker F1 Problem After Qt6 Install
-
After removing Qt 6 ?
-
wrote on 8 Mar 2021, 20:17 last edited by
@SGaist I removed Qt6 and reinstalled it, then I uninstalled TexMaker and reinstalled it. Same problem, note that this is on win 10. Win 10 also has qt5 installed. I have not tried it on Mint Linux.
The question now is should I remove TexMaker and all versions of qt, the try TexMaker with no qt installed?
-
@SGaist I removed Qt6 and reinstalled it, then I uninstalled TexMaker and reinstalled it. Same problem, note that this is on win 10. Win 10 also has qt5 installed. I have not tried it on Mint Linux.
The question now is should I remove TexMaker and all versions of qt, the try TexMaker with no qt installed?
@ofmrew said in TexMaker F1 Problem After Qt6 Install:
The question now is should I remove TexMaker and all versions of qt, the try TexMaker with no qt installed?
That was the idea, yes.
-
@ofmrew said in TexMaker F1 Problem After Qt6 Install:
The question now is should I remove TexMaker and all versions of qt, the try TexMaker with no qt installed?
That was the idea, yes.
wrote on 23 Apr 2021, 19:06 last edited by@SGaist I am getting back to this problem; however, to do so will mean that I will need to remove Qt and the Qt3D that I painfully installed. I would like to move Ninja and Vulkan so that I will not need to build them, also. I would like to save conan3D which was the conan build directory, but will that not work when I reinstall Qt6? Any advise? I wish there was a workaround to this TexMaker problem.